Preparation before the test of AC Resonant Test System with Variable Frequency

Mar. 27, 2024

The test personnel should not be less than 2 people. During use, they should strictly abide by the safety operation procedures for high-voltage tests;
In order to ensure the safety and correctness of the test, in addition to being familiar with the product manual, it is also necessary to strictly follow relevant national standards and procedures for test operation;
When opening the packing box, the test personnel should check the equipment according to the packing list. If any discrepancy is found between the equipment and the packing list, they should immediately contact;
The variable-frequency series resonance test device should be used by high-voltage test professionals, who should carefully read the instructions before use and undergo repeated operational training;
When using AC Resonant Test System with Variable Frequency, it outputs high voltage or high frequency voltage, so it must be grounded reliably and operated safely;
The connecting wires cannot be connected incorrectly, and the wiring must be connected according to the circuit diagram on the "Notes", otherwise it may cause damage to the test device;
Whether it is a test on the tested object or an air-lift test, the following section of the reactor must be separated from the ground with an insulating support;
Before testing the tested object, conduct an air-lift test on the equipment with a test voltage of 80% of the rated voltage of the equipment.