How to operate the on-site test of the AC Resonant Test System with Variable Frequencye

　　To operate the onsite test of the AC Resonant Test System with Variable Frequency,you can follow these general steps: 　　1.Setup the Test System:

　　Connect the AC Resonant Test System to the power source and the test object(e.g.,transformer,cable,etc.).

　　Ensure all connections are secure and follow the system's manual for proper setup.

　　2.Set the Test Parameters:

　　Choose the appropriate test voltage and frequency for the test object.

　　Set the frequency to the desired value for the resonant test.

　　Adjust the voltage levels based on the specifications of the test object.

　　3.Perform the Test:

　　Start the test by energizing the AC Resonant Test System.

　　Monitor the test parameters such as voltage,current,and frequency during the test.

　　Observe the behavior of the test object and check for any abnormal responses.

　　4.Record and Analyze Results:

　　Record the test results including voltage,current,frequency,and any observations made during the test.

　　Analyze the results to determine if the test object meets the required specifications.

　　Compare the test results with the standards or specifications for the test object.

　　5.Safety Precautions:

　　Follow all safety precautions provided in the manual of the AC Resonant Test System.

　　Ensure that all personnel involved in the test are aware of the safety procedures.

　　Use appropriate personal protective equipment during the test.

　　Remember that the specific steps may vary depending on the manufacturer and model of the AC Resonant Test System.Always refer to the system's manual for detailed instructions on how to operate it effectively.